HARMAN KARDON AVR85
Instrukcja Obsługi

Basic Operation
24

1. Tune to the desired preset station. 2. Press the Memo button ^ r for more than three seconds. 3. Note that a character on the left side of the main information display will start to blink. 4. Enter the first character of the name using either the front panel Tune � or ¤ buttons � or the alphanumeric buttons x on the remote. A. To use the front panel buttons simply press and hold Tune � � button until the desired letter or number appears. Note that the upper case alphabet will appear, followed by the numbers 1 through 0, and then a indicating a blank space. Tapping the button will advance the display one character at a time; holding it down will move the display quickly. If you pass by the desired character, use the Tune ¤ � to move the display in reverse. After entering the first character, press to move to the next position Memo ^ and note that the next digit will blink. Use the same procedure outline above to enter a character. When you have entered a digit or �blank� in all five spaces, press and hold the Memo button ^ for a second to confirm the entry B. To use the remote for character entry, press the button corresponding to the desired letter or number. Press it once to enter the first printed letter, twice for the second, three times for the third and four times for the number. Press the �9� button to enter a blank space. (For example, press the �ABC� button once to enter an �A,� three times for a �C� and four times to enter a �1�.)

Use the Memo button v to move to the next digit position. When all five spaces have been filled, press and hold the Memo button again for a second to confirm the entry. Once a station name has been attached to a preset position, the station�s frequency will appear briefly when the unit is tuned to that station. After a few seconds the preset name will appear in the display. Tuning Preset Stations Stationsrecalled in athe tuner�s memory may be preset into number of ways. 1. To recall a station directly enter a number from 1 to 30 using the number buttons on the remote x. a. To enter a single digit memory location, press 0 before the number, or enter the number and wait a few seconds. b. If an invalid number (other than 1�30) is entered in error, that number will flash to alert you that the entry is invalid and the display will return to the previous frequency display. 2. To scan through the list of preset stations, press the P-Set� or P-Set ¤ button on the front panel � or the Channel buttons u on the remote.Press once to move up or down thorough the memory presets one by one, or press and hold the button to quickly scan through the list of stations. 3. To automatically review each station in the memory, press the P-Scan button w �. Note that the P-Scan indicator G will blink.

� The tuner will move up through the list of stations, pausing to play each for five seconds. Note that preset numbers where no station has been programmed will be skipped. � When the desired station is reached press P-Scan �. Clearing Preset Stations Once stations are programmed into the preset memories, it is possible to remove them individually or as a group. To remove a single station from the memory: 1. Recall the station by pressing the buttons on the remote corresponding to the station�s memory location. 2. Press the Memo button ^ or v and observe that the Memo indicator O will blink. 3. While the indicator is blinking, press the Clear button & within five seconds. The word CLEAR will show briefly to confirm that the memory position has been cleared. To clear all memory locations for the tuner, as well as all volume level and surround mode memories: 1. Press the Memo button v and the Clear button x at the same time. Note: When a complete memory clear is performed the AVR85 will turn off and then on as part of the process. After clearing the memory it is necessary to reset all stations and set up parameters.